Alamo TS-100A - Manual (Page 18)

© 2005 Alamo Group Inc. Section 2 - 2
Maverick (NH TS-100A,115A ,125A,135A Asy. Man) 01/05
To help you assemble your new Machete Boom and mount it to your tractor, a detailed assembly
instruction Manual is being provided with the mount kit to provide detailed instructions and part
numbers. Please consult this document for specific information. When needed, you can get
additional information or clarification from Your Dealer or Alamo Group Customer Service.
This publication provides general information not specifically for your case or tractor, but, in
connection with the drawings, this publication offers you some valuable assistance - please read
it thoroughly.
These mount kits are made for selected tractors with standard configurations. Only the noted
options and tire sizes listed in the Mounting Specifications will work with these mount kits. Other
options, front axles, or different tire sizes may prevent the mount kit from fitting your nonstandard
tractor. Alamo Group cannot take responsibility for these problems or any modifications made to
the unit.
GENERAL INFORMATION:
The tools you will need at the assembly site are as follows:
1. Impact wrench or socket and ratchet set.
2. Rubber mallet.
3. Box-end, Allen, and adjustable wrenches.
4. Alignment pins.
5. Forklift or hydraulic floor jacks with rolling back boards.
6. Small chain hoist or block-and-tackle.
7. Multidirectional Levels.
8. Hydraulic Filter Buggy or Cart.
9. Safety shoes, safety glasses, and gloves.
A hard hat should be worn by anyone working under any raised component.
Remember to follow each step closely and cautiously. Be aware of all support personnel at all times.
Keep the assembly area as clean as possible; clean up all spills when they occur. An uncluttered
assembly area and a crew that is sensitive to the hazards involved in putting this implement together
will help prevent accidents. Keep all unauthorized personnel from the area. Do not allow children near
the assembly site nor allow them on or near the tractor after assembly. There is no safe place for
anyone except the operator on the tractor and those assisting with the assembly.
General Information / Installation Requirements
Throughout these instructions, references are made to right or left directions. Right and left are
determined by sitting on the tractor seat and facing the direction of travel forward always.
This is the Safety-Alert symbol. When you see this symbol on your machine or in
these instructions, be alert to the potential for personal injury. Follow recommended
precautions and safe operating practices.
DANGER! A signal word - DANGER, WARNING, or CAUTION - is used with the Safety Alert
symbol. DANGER identifies the most serious hazards.