Alamo TS-100A - Manual (Page 29)

© 2005 Alamo Group Inc.
Section 3 - 5
Maverick (NH TS-100A,115A,125A,,135A Asy. Man) 01/05
Installing Pump to Pump Mount Weldment :
1. Install Pump to Pump Mount Weldment. The Pump has the tube half of driveline attached
and clamp yoke tightened. To install the pump and driveline half it is best to use an assistant or
overhead hoist to help you align the drivelines halves as they are slid together, the Driveline must
be timed (universal joints aligned the same) as shown in the pump & driveline schematic on (See
Figure 10 thru 17).
Slide Driveline half and pump together until the shoulder on the pump slide
in the hole on the pump mount weldment.
When installing the pump always keep ports sealed to keep them clean and free of
contamination. The pump MUST be turned correctly. This can be done by making certain that the
pressure filter that is mounted on top of the pump is up.
Install the two 1/2" X 1-1/2" long pump mount bolts (P/N 02892000) and two 1/2"
lockwashers (P/N 00001300). Tighten the two pump mounting bolts.
Pump / Drive Assembly Instructions
Installing Driveline Half to Pump :
1. Install Driveline Half to Pump. Install the clamp yoke of the tube half of driveline onto the
pump, slide the clamp yoke on pump shaft until you have about 1/8" to 1/4" gap between yoke
and pump. Do not install yoke so far on pump shaft that yoke will rub against pump in anyway.
Tighten the two bolts and nuts on clamp yoke at this time. (See Figure 9 & 14)
123456
123456
123456
123456
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
Figure 9
Driveline Tube Half with
Clamp Yoke
1
1
1
1
Pump Mntg Bolts
P/N 02980666 Pump
Mount Weldment
Figure 10
12345678901
12345678901
12345678901
12345678901
123456789012
123456789012
123456789012
123456789012
Mounting Bolts
Bolts To
Tractor Bolster 123456789
123456789
123456789
123456789
Mounting Bolts
1234
1234
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
Install Pump Driveline cover here
1
1