Alamo TS-100A - Manual (Page 27)

© 2005 Alamo Group Inc.
Section 3 - 3
Maverick (NH TS-100A,115A,125A,,135A Asy. Man) 01/05
Pump / Drive Assembly Instructions
Figure 3
4 Non-Threaded Holes
4 Threaded
Holes
Pulley Adapter
P/N 02980699
2. Install Shaft Half of Driveline with Flange Yoke. Note the driveline universal joints should be timed
(See Figure 4). Slide the two driveline half assemblies apart and lay the tube half aside for now. Make
certain that the four retaining bolts for the Pulley adapter to the crankshaft pulley have been tightened.
3. Check the length of the spline shaft of the driveline is a must. The shaft should be 12-1/
2" long (Measure Shaft Only). on some drivelines this shaft will have to be cut. The correct way to cut
this shaft is with a saw, after cutting use a file & grinder to chamfer the cut end and clean the splines.
DO NOT cut shaft with a Torch as this will change the hardness of the shaft.
4. From the side of the tractor (LH side) slide the Shaft Half of driveline shaft end first down into the
opening below the radiator from engine side, insert it through the existing hole and/or cut hole
combination until the shaft is pointed toward the front of the tractor, and the flange yoke is over far enough
to align with the four threaded pulley adapter holes.
5. Align the four holes in the flange yoke of driveline with the four threaded holes in the pulley adapter.
Install the four retaining 7/16" X 1-1/4" long bolts (P/N 02976344) and 7/16" lockwasher (P/N 00022200)
into flange yoke into adapter, tighten them at this time. These four bolts can be tightened by using a
long socket extension run through along side the driveline shaft.
6. Set the tube end of driveshaft aside for now as it will be installed later. But always remember the
driveline universal joint must be aligned (timed) when assembling the driveline halves.
Figure 4A
Splined Clamp Yoke
/ Tube End Flange Yoke
/ Shaft End
Drive Shaft
Assembly
Figure 4
Figure 3A