Alamo TS-100A - Manual (Page 86)

© 2005 Alamo Group Inc. Section 9 - 4
Maverick (NH TS-100A,115A, 125A, 135A Asy. Man) 01/05
Figure 5
8. Heads Are received from the Factory with
the Cylinder and Head hoses Attached to Head.
The head will be received with the door cylinder,
swivel cylinder and Motor attached to the head.
The Hoses for the cylinders and the motor will
connect to the boom. There is a decal that is
installed on the side of the boom that shows
where the hoses connect to the fitting that have
the metal caps on them. The fittings for the head
are located on the side of the main Boom. The
hoses must be connected in the correct order to
make certain of correct operation (See Figure 4,
5, 6, 7, 8, 9 & 10).
9. Two Head Options. There are two heads
available, 60" (See Figure 4,5 & 6) which has the
head Swivel attachment on it. The 50" Head which
will not have the swivel attachement (See Figure 9
& 10) If using the 50" head leave the ports for
swivel cylinder on boom capped (See Figure 8)
10. Connect Hose From Boom to Control
Valve. The cylinder hoses will connect to the
control valve mounted on the front of the tractor
with the exception of the Door and Swivel Cylinder
hoses they will connect to the diverter valve and
then there are two hoses that connect to
thediverterr valve to the 6 spool control valve (See
Figure 11). The hoses for door and swivel will be
routed under the tractor along the center under
frame weldment to the diverted valve which will be
mounted on the LH side of the tractor on the front
frame mount bracket.
Figure 4
Figure 6
Figure 7
60 Inch Head with
Swivel Hitch Mount
60 Inch Head with
Swivel Hitch Mount
60 Inch Head with
Swivel Hitch Mount
Boom / Head Installation