Alamo TS-100A - Manual (Page 19)

© 2005 Alamo Group Inc. Section 2 - 3
Maverick (NH TS-100A, 115A, 125A, 135A Asy. Man) 01/05
WARNING! Safety signs with signal word WARNING are typically used to point out more
serious hazards.
CAUTION! General precautions are listed on CAUTION safety sign. CAUTION also calls
attention to safety messages in these instructions.
GENERAL INFORMATION
The tools you will need at the assembly site are as follows:
1. Welding equipment (including correct head gear, eye shields, and protective clothing.)
2. Impact wrench or socket and ratchet set.
3. Rubber mallet.
4. Box-end, Allen, and crescent wrenches.
5. Alignment pins.
6. Phillips and plain-head screwdrivers.
7. Forklift or hydraulic floor jacks with rolling back boards.
8. Over head hoist and floor jacks
9. Jack Stands and/or other support devices that are strong enough to support tractor and
components
10. Multidirectional Levels.
11. Paint Scraper.
12. Hydraulic Filter Buggy or Cart.
13. Safety shoes, safety glasses, and gloves. A hard hat should be worn by anyone
working under any raised component.
Remember to follow each step closely and cautiously. Be aware of all support personnel at all times.
Keep the assembly area as clean as possible; clean up all spills when they occur. An uncluttered
assembly area and a crew that is sensitive to the hazards involved in putting this implement together
will help prevent accidents. Keep all unauthorized personnel from the area. Do not allow children near
the assembly site nor allow them on or near the tractor after assembly. There is no safe place for
anyone except the operator on the tractor and those assisting with the assembly.
General Information / Installation Requirements