Alamo TS-100A - Manual (Page 105)

© 2005 Alamo Group Inc. Section 10 - 11
New Holland (NH TS-100A, 115A, 125A, 135A Asy. Man) 01/05
CONTROL VALVE - INSTRUMENTATION
Maverick Operator Interface
: (continued)
* At this time the motor circuit is powered and the mower head motor is active. This screen also shows
the tank temperature in degrees Fahrenheit. To turn off the motor at this time Key F-1.
* The Joystick Master control switch must be off to prevent accidental movement of boom and cutting
head when ever mower is not being operated, such as when in transport.
Cylinder Supply Pump Pressure
Adjust (If Needed):
Special Note: If after setting the display
controls, check to make certain that functions
operate correctly. If the Boom will not lift. The Pump
for the Cylinder supply may have to be adjusted.
This is a simple process that will require a 7/16"
wrench for this adjustment and a 1/2" wrench for the
locking nut. Looking on the LH side of the pump
there are two adjustments, one has a 7/16" hex
head and the other a ridged round head, Only adjust
the one with the hex head. DO NOT adjust or
change the round ridged adjustment as it is set from
the factory. Adjust the 7/16" hex one by turning it in
till it seats completely (Do not force adjustment after
is seats). Then back it back out 1/2 turn, this will give
you the 2800 psi required to operate the boom. (See
Figure 16 & 17). Hold the adjusting nut while turning
the locking nut so the adjustment nut does not turn
with it changing the setting.
Pressure Adjust Nut (7/16" Hex)
&
Locking Nut (1/2" Hex)
Pressure Adjust
Control (7/16" Hex)
FIGURE 16
FIGURE 17