Alamo TS-100A - Manual (Page 48)

© 2005 Alamo Group Inc. Section 5 - 8
Maverick (NH TS-100A,115A ,125A,135A Asy. Man) 01/05
Frame Installation:
1. Frame Components. The frame will include
the rear axle mounts, a LH & RH Frame rail. Two
front frame mounts, a LH & RH. One center frame
weldment. (See Figure 17, 18, 19, 20 & 21)
2. Install Frame Components. The Frame
components will only fit one way. The Frame com-
ponents are a Bolt together assembly no welding
will be required. The Frame components will bolt
together and to the tractor using mostly 3/4" and/or
20 mm bolts. Each 3/4" & 20 mm bolt will use
hardened flat washers, one on the head side when
bolts go into the tractor castings. Two washers
used when bolts use a nut and go through the
frame. These hardened washers are important.
Frame Installation
Figure 17
Figure 18
Figure 19
Figure 20 Figure 21
Center Frame
Weldment
P/N 02981168
LH Front Frame
Mount Weldment
P/N 02982014
RH Front Frame
Mount Weldment
P/N 02982015
RH Rear Frame
Mount Weldment
P/N 02982005
LH Rear Frame
Mount Weldment
P/N 02982006