Alamo TS-100A - Manual (Page 32)

© 2005 Alamo Group Inc. Section 3 - 8
Maverick (NH TS-100A,115A,125A, 135A Asy. Man) 01/05
Pump / Drive Assembly Instructions
Install Tractor Guards & Covers:
1. Reinstall LH Side Engine Guards. The left
hand side engine guards need to be reinstalled
using the original hardware (See Figure 18). These
guard are to gain access so the pulley adapter
could have been installed as shown (See Figure
19).
2. Reinstall Top Cover. There is a top cover
that bolts onto the front of the tractor that is
removed to make certain that the hoses that run
underneath (See Figure 20) are tied back to
prevent them from rubbing on the driveshaft that
was installed, this is very important to prevent
damage to the hoses (See Figure 21). The front
cover plate will be installed using the original
hardware.
3. Install Pump Mount Driveshaft Cover. The
Pump Mount has a bolt on cover on top of it (See
Figure 17 & 21). The cover and bolts are furnished
with kit. In figure 21 is shown without pump in-
stalled, this is for illustration only. Do not install
cover before pump is installed.
4. Review this section and make certain all
components are installed and tightened to speci-
fication (Bolt Toque Chart) and hoses are se-
cured so as not to interfere with another compo-
nent.
Figure 18
LH Side Engine
Guards Removed
From Tractor
Figure 19
Air Conditioner &
Oil Cooler Hoses
Figure 20 Figure 21
Air Conditioner &
Oil Cooler Hoses
Front Cover
Pump
Mount
Cover Bolts
Here