Alamo TS-100A - Manual (Page 72)

© 2005 Alamo Group Inc. Section 8 - 8
Maverick (NH TS-100A,115A , 125A, 135A Asy. Man) 01/05
Joystick / Electrical Mounting
FIGURE 16
K3
X1
Display Control
Box Connections
8. Wire Exterior & Interior Harness Schematic. The wire harness schematics and instructions
will need to be used together to install the wire harness. The interior Harness and the exterior harness
will connect together with one plug connection. Figure 14, 16,17, 18 & 19) pertain to the interior harness,
Plugs have codes on them to identify where they connect, the connections will have codes on them to
identify where the connection goes. The code on the plug and the code on the connection may not be the
same, see the code connection listings in the illustrations to identify the connection location.
FIGURE 18
FIGURE 17
Display Control
Box Connections
Cut Notch in Small cover panel to
allow harness to fit through
Can1
Can2 C1
XS Module
P/N 02981533
FIGURE 15
9. Plugs for Display Control Box. The wire plugs for
the display control box will come up through the small
cover on top of the right hand side panel (See Figure 16,
17, 18 & 19). When the small cover is replaced the plugs
and wires need to be moved to the back of the panel near
the RH rear cab post (See Figure 17 & 18). Cut a notch in
the panel at the rear so the cover will fit down around the
wire harness plugs (See Figure 17 & 18). Also the rear
tractor panel will need a notch cut in it to allow the wire
harness to be installed between the side and rear panel.
Cut this notch near the bottom of the rear panel (See
Figure 19)
FIGURE 19
Rear
Panel
Wire Harness to Joystick