Alamo TS-100A - Manual (Page 42)

© 2005 Alamo Group Inc. Section 5 - 2
Maverick (NH TS-100A,115A ,125A,135A Asy. Man) 01/05
Battery Holder Relocation:
1. The Battery Relocation. The battery holder is
located on the RH side of the tractor (See Figure 1) .
It will have to be relocated. The mount kit will include
a battery relocation kit. The battery relocation kit
includes a mounting bracket (See Figure 2) that will
relocate the battery tray farther to the rear. This is
done so the Boom Swing will not hit battery when in
the transport position. The RH Step Will need to be
removed to allow access to relocate battery.
2. Remove Factory Battery Cover, Battery,
Battery Tray and Battery Tray mount. Remove the
battery cover (See Figure 3), Remove the battery
cables from the battery. Remove the battery from
the battery tray. Unbolt the battery tray from the
tractors factory mount bracket. Remove the factory
mounting bracket from the tractor (See Figure 4).
3. Install Replacement Battery Tray Bracket.
Install the replacement battery tray bracket (See
Figure 2) using the same bolts and holes as the
original bracket. This Bracket is designed to move
battery further back. Install original battery tray using
original hardware. Reinstall battery into batter tray
(See Figure 3). DO NOT reconnect battery cables at
this time, leave them off and make certain they do
not make contact with the battery connections as
you do not want the battery connected during instal-
lation. Replace the battery cover (See Figure 1) for
now this will protect battery and cover.
Figure 1
Figure 2
Battery
Relocation
Bracket
P/N
02981725
Figure 3 Figure 4
Battery Holder Relocation