Alamo TS-100A - Manual (Page 45)

© 2005 Alamo Group Inc. Section 5 - 5
Maverick (NH TS-100A,115A ,125A/,35A Asy. Man) 01/05
4. Install Pick Up Tube & Gauge Sending Unit in
new Tank. The Pickup gauge sending unit from the
factory tank will be installed into the new tank. This is
recommended to be done before mounting the new
tank to the tractor (See Figure 13). The new tank will
have a fuel capacity of 51 gallons
5. Install the new mount brackets to the tractor
frame. The tank mounting brackets will bolt to the
tractor the same as the factory brackets that were
removed. Make certain that the brackets are in-
stalled correctly, the front bracket will have 2 outer
holes (same as the tank see Figure 11 & 13). The
rear bracket will have 1 hole in the outer end (same
as the tank, See Figure 12 & 13)
6. Install The new Fuel tank onto Tractor. The
new fuel tank with the gauge sending unit slide in on
top of the new mounting brackets with the fuel cap to
the front (See Figure 14). Connect lines to fuel pick
up connections, connect wiring to fuel gauge send-
ing unit. (See Figure 14)
7. Bolt Tank to the Mounting Brackets. Bolt the
tank to the mounting brackets, there are two bolts in
the front bracket and one bolt in the rear bracket.
(See Figure 15)
8. Install New replacement Step. The new Re-
placement step is a bolt on weldment that will bolt to
the new fuel tank with four bolts, note: below the
step is painted yellow for clarity only (See Figure
16).
Figure 13
Pick Up Tube Unit
Front
Rear
Mounting
Tabs
Tank
P/N 02982198
Figure 14
Front
Bracket
(2 Bolts)
Rear
Bracket
(1 Bolt)
Figure 15
Figure 16
Fuel Tank Replacement