Alamo TS-100A - Manual (Page 55)

© 2005 Alamo Group Inc. Section 5 - 15
Maverick (NH TS-100A,115A ,125A/,35A Asy. Man) 01/05
Front Axle Stabilizer Installation - 30 FT Model (Standard)
This kit is tied to the oil supply at the Lift Cylinder for
the boom, the upper pressure supply hose (# 4 hose with
blue plastic tie) is tee'd to the "B" port of valve for the lift
cylinder and connected to the Base end of the stabilizer
cylinder. The lower Hose is connected to the rod end of the
cylinder and is connected to the tank return hose at the
tank. Install the cylinder with the rod end toward the axle
and the base end of cylinder up to the bracket (item 3)
bolted to tractor frame. Number 4 hose with a blue plastic
tie at the front side of tank (See Figure 41 through 48).
The Brackets bolt to the tractor axle and form a
clamp around front axle housing (item 1 & 2). The Stabi-
lizer cylinder is charged only when the boom lift cylinder is
activated and is controlled automatically with the boom lift
controls.
The three axle brackets are as follows
Item Part No Qty Description
1 02983143 1 Top Axle Bracket
2 02983144 1 Bottom Axle Bracket
3 02982330 1 Stabilizer Support Bracket
4 02981316 1 Hydraulic Cylinder
See Mount Kit & Component ID section for Axle Stabilizer
complete component and hardware kit list.
2. When installed correctly the three components
should be aligned as show (See Figure 44). The upper and
lower bracket should have the same gap between them in
front as in the back to make certain brackets are even.
Check the hose connections and all mounting bolts for the
axle stabilizer kit.
12
12
123
123
123
1234
1234
1234
1234
123456
123456
123456
123456
123456
P/N 02981316 Cylinder Assembly
(Included in Front Axle Stabilizer Kit Only)
P/N 02982320 Cyl Sup-
port Weldment (In-
cluded in Front Axle Sta-
bilizer Kit Only)
Figure 42
Figure 43
Pressure Hose End
Return Hose End
Axle End
Support Bracket End
Front Axle Stabilizer Kit Installation:
1. Install Front Axle Stabilizer Kit (Kit P/N 02981895). The front axle stabilizer kit is standard on the
30 foot model. The front axle stabilizer kit will consist of all brackets and hardware to install to front RH
side of 4 wheel drive axle RH side of tractor frame
P/N 02983143
New front axle
bracket (top)
P/N 02983144
New front axle
bracket (bottom)
Back side
RH Front
Tire side
Engine side
Figure 41
1234
1234
1234
1234
123456
123456
123456
123456
123456
12
12
12
123
123
123
Upper Cyl
Mount Bolt
Lower Cyl
Mount Bolt
Upper Clamp
Mount Bolt
Figure 44