Burkert Type 8694 - Manual (Page 54)

54
Start-up
→
To operate the buttons and DIP switches, for
Version 1:
unscrew the body casing
Version 2: unscrew the transparent cap
DIP Switches
Key 2
Key 1
LED 2
LED 1
Communications
interface
Version 1
Version 2
1 2 3 4
ON DIP
Key 1
Key 2
LED 1
LED 2
Communications interface
Figure 37: Automatic adjustment X.TUNE
→
Start the X.TUNE by pressing button 1 20) for 5 s.
While the X.TUNE is running, LED 1 flashes quickly (green).
When the automatic adjustment is complete, LED 1 flashes slowly (green) 21) .
The changes are automatically transferred to the memory (EEPROM) provided the X.TUNE function is successful.
Important: When the X.TUNE function is activated, the actuator cannot be actuated via the AS-Interface
communication.
Seal
body casing
Body casing
Figure 38: Position of the seal in the body casing
→
Version 1: Check that the seal is correctly positioned in the body casing.
NOTE!
Damage or malfunction due to penetration of dirt and humidity!
• To observe protection class IP65 / IP67, screw the transparent cap in all the way.
→
Close the device (assembly tool: 674077 22) ).
20)
The X.TUNE can also be started via communications software.
21)
If a fault occurs, LED 1 is lit red.
22)
The assembly tool (674077) is available from your Bürkert sales office.
English
Type 8694