Burkert Type 8694 - Manual (Page 38)

38
Installation
3. Install pneumatic connection between positioner and actuator
Pilot air outlet 2
1
Pilot air outlet 2
2
Upper pilot air port
Lower pilot air port Example ∅ 80, CFA
Figure 23: Installing the positioner
→
Screw the plug-in hose connectors onto the positioner and the actuator.
→
Using the hoses supplied in the accessory kit, make the pneumatic connection between the positioner and
actuator with the following “Table 13: Pneumatic connection to actuator - CFA” or “Table 14: Pneumatic con-
nection to actuator - CFB”.
NOTE!
Damage or malfunction due to ingress of dirt and moisture!
To observe protection class IP65 / IP67:
• In the case of actuator size ∅ 80, ∅ 100
connect the pilot air outlet which is not required to the free pilot air port of the actuator or seal with a plug.
• In the case of actuator size ∅ 125
seal the pilot air outlet 22 which is not required with a plug and feed the free pilot air port of the actuator via a
hose into a dry environment.
Control function A (CFA)
Process valve closed in rest position (by spring force)
Actuator size ∅ 80, ∅ 100
∅ 125
P
ositioner
Pilot air outlet
2
2
2
1
2
2
2
1
Actuator
Upper pilot air port
Lower pilot air port
Dry area
Table 13: Pneumatic connection to actuator - CFA
English
Type 8694