Burkert Type 8694 - Manual (Page 44)

44
Electricalinstallation24VDC
10. ELECTRICAL INSTALLATION 24 V DC
All electrical inputs and outputs of the device are not galvanically isolated from the supply voltage.
Two kinds of connections are used for the electrical bonding of the positioner:
• Cable gland
with cable gland M16 x 1.5 and screw-type terminals
• Multi-pole
with circular plug-in connector M12 x 1, 8-pole
10.1. Safety instructions
DANGER!
Risk of electric shock!
• Before reaching into the system, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
WARNING!
Risk of injury from improper installation!
• Installation may be carried out by authorized technicians only and with the appropriate tools!
Risk of injury from unintentional activation of the system and an uncontrolled restart!
• Secure system from unintentional activation.
• Following installation, ensure a controlled restart.
10.2. Electrical installation with circular plug-in connector
DANGER!
Risk of electric shock!
• Before reaching into the device or the equipment, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
10.2.1. Designation of the contacts Type 8694
View without body
casing Circular plug
M12 x1, 8-pole
6
1
7
5
4
3
2
8
Figure 28: Circular plug M12 x 1, 8-pole
English
Type 8694