B&K Precision MDL Series - Programming Manual - Manual (Page 96)

96
213 RS-232 buffer overrun error
216 RS-232 receiver framing error
217 RS-232 receiver parity error
218 RS-232 receiver overrun error
220 Front panel UART overrun
221 Front panel UART framing
222 Front panel UART parity
223 Front panel buffer overrun
224 Front panel timeout
225 Front CRC check error
226 Front cmd Error
401 CAL switch prevents calibration
402 CAL password is incorrect
403 CAL not enabled
404 Computed readback cal constants are incorrect
405 Computed programming cal constants are incorrect
406 Incorrect sequence of calibration commands
407 CV or CC status is incorrect for this command
603 FETCH of data that was not acquired
604 Measurement overrange