B&K Precision MDL Series - Programming Manual - Manual (Page 44)

44
Parameters None
Examples STAT:QUES:COND?
Returned Parameters (register value)
Related Commands STAT:OPER:COND?
STATus:QUEStionable:ENABle
This command sets or reads the value of the Questionable Enable register. This register is a mask for
enabling specific bits from the Questionable Event register to set the questionable summary (QUES) bit
of the Status Byte register. This bit (bit 3) is the logical OR of all the Questionable Event register bits
that are enabled by the Questionable Status Enable register. This command is not channel specific and
applies to the entire mainframe.
Command Syntax STATus:QUEStionable:ENABle
Parameters 0 to 65535
Default Value 0
Examples STAT:QUES:ENAB 32 STAT:QUES:ENAB 1
Query Syntax STATus:QUEStionable:ENABle?
Returned Parameters (register value)
Related Commands STAT:QUES?
STATus:PRESet
When this command is sent, the SCPI event registers are affected as follows: All bits of the following
registers are cleared to zero (0):
• Questionable Event Enable Register
• Channel summary Event Enable Register
• Operation Event Enable Register
NOTE: Registers not included in the list above are not affected by this command.
Command Syntax STATus:PRESet
Parameters None
Examples STAT:PRES