B&K Precision MDL Series - Programming Manual User Manual
Page 30
30
*ESE
This command programs the Standard Event Status Enable register bits. The programming determines
which events of the Standard Event Status Event Register (see *ESR?) are allowed to set the ESB (Event
Summary Bit) of the Status Byte register. A "1" in the bit position enables the corresponding event. All
of the enabled events of the Standard Event Status Event register are logically ORed to cause the Event
Summary Bit (ESB) of the Status Byte Register to be set. See Section 1.4 Programming the Status
Registers for descriptions of the Standard Event Status registers. The query reads the Standard Event
Status Enable register.
Command Syntax *ESE
Parameters 0 to 255
Power-On Value See *PSC
Example *ESE 129
Query Syntax *ESE?
Returned Parameters
Related Commands *ESR? *PSC *STB?
*ESR?
This query reads the Standard Event Status register. Reading the register clears it. The bit configuration
of this register is the same as the Standard Event Status Enable register (see *ESE). See Section 1.4
Programming the Status Registers for a detailed explanation of this register.
Query Syntax *ESR?
Parameters None
Returned Parameters
Related Commands *CLS *ESE *ESE? *OPC
*IDN?
This query requests the electronic load to identify itself. It returns the data in four fields separated by
commas.
Query Syntax *IDN?
Parameters None
Returned Parameters
Field
Information
B&K Precision
manufacturer
xxxxxx
model number
xxxxxxxxxxxxxxxxxx serial number or 0
x.xx
firmware revision
Example: BK PRECISION, MDL001, 600150010677510002, 1.43