B&K Precision MDL Series - Programming Manual - Manual (Page 49)

49
[SOURce:]INPut:SYNCon
Channel Specific
This command enables or disables to change the electronic load inputs when INP:ALL command is
received.
Command Syntax [SOURce:]INPut:SYNCon[:STATe]
Parameters 0 | 1 | OFF | ON
*RST Value ON
Examples INP:SYNC 1
Query Syntax INPut:SYNCon[:STATe]?
Returned Parameters 0 | 1
Related Commands INP:ALL
[SOURce:]INPut:SHORt
Channel Specific
This command programs the specified electronic load module to the maximum current that it can sink
in the present operating range.
Command Syntax [SOURce:]INPut:SHORt[:STATe]
Parameters 0 | 1 | OFF | ON
*RST Value OFF
Examples INP:SHOR 1
Query Syntax INPut:SHORt:STATe?
Returned Parameters 0 | 1
Related Commands INP
[SOURce:]REMote:SENSe
Channel Specific
This command is used to select the remote measure mode for the load.
Command Syntax [SOURce:]REMote:SENSe[:STATe]
Parameters 0 | 1 | OFF | ON
*RST Value 0
Examples REM:SENS 0