B&K Precision MDL Series - Programming Manual - Manual (Page 58)

58
Examples VOLT:RANG:AUTO 1
Query Syntax [SOURce:]VOLTage:RANGe:AUTO?
Returned Parameters
[SOURce:]VOLTage:ON
Channel Specific
This command sets the voltage of sink current on.
Command Syntax [SOURce:]VOLTage[:LEVel]:ON
Parameters 0 through max. rated voltage.
Unit V (volts)
Examples VOLT 5
Query Syntax [SOURce:]VOLTage[:LEVel]:ON?
Returned Parameters
Related Commands VOLT:LATCh
[SOURce:]VOLTage:LATCh
Channel Specific
This command sets the action type of Von.
Command Syntax [SOURce:]VOLTage:LATCh[:STATe]
Parameters 0 | 1 | ON | OFF
*RST Value ON
Examples VOLT:LATC 1
Query Syntax [SOURce:] VOLTage:LATCh[:STATe]?
Returned Parameters 0 | 1
Related Commands VOLT:ON
[SOURce:]VOLTage:HIGH
[SOURce:]VOLTage:LOW
Channel Specific
These commands set the high and low current limit when the load is in constant voltage mode.
Command Syntax [SOURce:]VOLTage:HIGH
[SOURce:]VOLTage:LOW
Parameters 0 to max. rated current.
Unit A (amps)