Franklin Fueling Systems T5 Series Fuel Management System Programming Guide - Manual (Page 62)

58
Displayed Alarm /
Warning
Device Description Recommended Actions
Pump Communication Fail TPI Communication from the TPI to
the STP controller has failed.
Check all wiring connections and ensure that there is power supplied
to the Smart Controller.
Pump In Water TPI The water level has risen to within
3 inches of the programmed intake
level.
Ensure proper programming of the TPI and calibration of the Smart
Controller. If correct, have water removed from the tank
Relay Fault TPI The STP controller is reporting a
relay fault error.
Refer to the applicable Smart Controller Installation guide for details.
Short Circuit TPI The STP controller is reporting a
short circuit condition.
Unbalanced Load TPI The STP controller is reporting an
unbalanced load condition.
Unbalanced Voltage TPI The STP controller is reporting an
unbalanced voltage condition.
Under Voltage TPI The STP controller is reporting a
voltage level under 200VAC.
Under Load TPI The STP controller is reporting an
underload condition.
Unknown Fault TPI The STP controller is reporting an
unknown fault code.
Check fault condition on Smart controller and contact FFS Technical
Services for more information
Printer Alarms
Check Printer
(Thermal Printer Only)
Printer Printer is out of paper, or the
printer door is open.
Make sure the printer has paper, and the printer door is closed
completely.
Printer Door Open
(Impact Printer Only)
Printer The system has detected the
printer door is open
Check to make sure the printer door is closed.
Printer Head
Temperature
(Thermal Printer Only)
Printer Print head high temperature
persists for at least 2 minutes
Printer will resume printing and the alarm will clear after a short cool-
down period. Keep the console area cool and ventilated. If the alarm
does not clear, contact FFS Technical Support.
Printer Motor
Temperature
Printer Printer motor has exceeded
temperature limit
Allow printer to cool. Keep the console area cool and ventilated. If the
alarm does not clear, contact FFS Technical Support.
Printer Paper Jam
(Impact Printer Only)
Printer Indicates that paper is jammed in
printer.
Carefully lift printer cover to inspect and remove the jammed paper.