Franklin Fueling Systems T5 Series Fuel Management System Programming Guide - Manual (Page 23)

19
Character Navigation Buttons
When prompted to enter system information, press the corresponding keys.
Character Selection: Selects between upper case letters,
lower case letters and numerals. Note how the characters
on the input buttons change as you scroll through the
options.
Backspace: This will move the cursor one space to the left
and delete the last character.
Clear: Deletes all of the data on the entry line.
Enter: Allows the data to be accepted. When this button is
pushed, the configuration will be set for the item you are
changing.
Cancel: Will return to the application you were changing. No changes will be made to console settings.
Restore Default: This button will restore the original settings programmed into the console during manufacture.
Application Menus
Each Application has an application menu button
. This will bring up different options depending upon which
application have selected. These are listed below:
Application Menu Topic Description
System Status Shows status of installed modules including slot#, state and software version
About Shows system software version and copyright information
Identification Shows system and controller serial #, Ethernet address, and date created
Options
Shows which options are installed
FMS Status Show status of Tanks, Lines, Sensors, Pumps and Deliveries
Control Allows controlling Tanks, Lines, Sensors, Pumps and Probes including initiating test and
to re-enable retest condition
Reports Allows printing various FMS reports
VRM Ullage
Pressure
Shows current ullage pressure as well as Operational Statistics and Compliance status
Dispensers Shows status of the dispensers
Control Allows running manual tests, calibrating sensors and clearing monitoring
Reports Allows printing, e-mailing or faxing of Monthly and Daily Vapor Recovery reports
SCM Status Shows pressure reading and enabled status of each containment area
Control Allows controlling the Secondary containment, including resetting alarms and
re-enabling containment.