Franklin Fueling Systems T5 Series Fuel Management System Programming Guide - Manual (Page 29)

25
Group Name Parameter Name
Parameter
Default
Description
Parameter
Input
RS-232 Baud Rate (9600) Data transmission speed in bits per second. 1200-57600
Data Bits (8) Number of bits that represent data. 7-8
Parity (None) Value of parity (error check) bit. None, Even, Odd
Stop Bits (1)
Number of stop bits, notifies receiving device of end of
data packet.
1-2
Response Time-out (8)
Period of time the console will wait for a response from a
remote device.
0-10
Relays
Channel # Name (Relay 1) Given name of the relay. abc#
Enabled (Yes) Whether the Relay is Enabled or not. Yes/No
Type (Unknown) Equipment connected to the relays output. Unknown
Submersible
Alarm
Solenoid
Dispenser
Other
Polarity (Normal) Allows the polarity to be inverted. Normal, Invert
Logic (OR Logic) The type of logic that the gate will use to process incoming
signals. In OR, if any combination of inputs is active, the
relay is active. With AND, when all inputs are active, the
relay is active. In XOR, if all inputs are in the same state
(on / off), the relay is inactive.
OR, AND, XOR
Physically Wired As
(Normally
Open)
How the relay is wired internally.
NO, NC
Number of inputs (0) Number of devices that can control the relay. 0-32
Input # Type (Unknown
Module)
Chooses which module is inputting the signal to the relay. Unknown
Controller
Power Supply
IO
AE
4-20
Probe
2-wire Sensor
3-wire Sensor
Low Voltage Inputs
Channel # Name (LV Input 1) Given name of input. abc#
Enabled (Yes) Whether the input is Enabled or not. Yes/No
Active State (high)
High will activate channel when high voltage is present.
Low will activate channel with no voltage present.
High / Low
Action (None)
Create an alarm or event timestamp None
Alarm
Event
LON
IFSF Node ID (1)
Allows the T5 Series console to communicate with an
IFSF POS (Point of Sale) System
0-127