Franklin Fueling Systems Tank Sentinel (Except TS-2001), AutoStik Jr, BulkStik, AutoStik II (1-4 Ch) Display & Keypad Assembly (P/N 010-0087) User Manual
Replacement part instructions

www.franklinfueling.com
PN & Rev: 0000203B
E - m a i l : t e c h @ f r a n k l i n f u e l i n g . c o m
F A X 1 - 2 0 7 - 2 8 2 - 9 0 0 2
T E L 1 - 8 0 0 - 9 8 4 - 6 2 6 6 P AG E
1 o f 1
s a l e s @ f r a n k l i n f u e l i n g . c o m F A X 1 - 2 0 7 - 2 8 3 - 0 1 5 8 T E L 1 - 8 0 0 - 8 7 2 - 3 4 5 5
REPLACEMENT
PART
INSTRUCTIONS
Tank Sentinel (Except TS-2001), AutoStik Jr, BulkStik, AutoStik II (1-4
Ch) Display & Keypad Assembly (P/N 010-0087):
Diagram: 1
Removal Steps (with
all Tank Gauge
power
OFF
):
1.) Remove the 20
conductor Cable
by pulling it
straight out
of its connector
2.) Remove the 7
Phillips head
screws (star
washers
attached)
3.) Remove
the
green
GROUND
wire lug and pull
the display board off the door
Installation Steps (with all Tank Gauge power
OFF
):
1.) Line up the new PC Board making sure all 3 indicator lights protrude through the
circular holes in the door
2.) Hold the PC Board in place while reinstalling the hold down screws with star
washers... don’t forget to reinstall the green ground wire
3.) Reinstall the 20-conductor cable back into the mating connector under the
DISPLAY
PC B
d
(gloss side up silver conductor side down)... Do this by grasping the flat
ribbon cable near the end and pushing it straight into its connector.
—
❖ —
Push
cable in -
glossy
side up,
silver
conductor
side down
Cable
Green
Ground
Wire