Franklin Fueling Systems T5 Series Fuel Management System Programming Guide - Manual (Page 48)

44
15. Under Dispenser Interface, select Fueling Points.
Note: A Fueling Point is anywhere a vehicle can stop and dispense fuel. Most dispensers have two fueling points. (front
and back).
16. Select the Number of Fueling points from the drop down list.
17. Under Fueling Points, select Fueling Point 1.
18. Select the Number of Hoses from the drop down list.
Note: Hose is defined as “each type of product that can be dispensed from a fueling point” A fueling point with only one
physical hose, but three available grades, would be entered as Number of Hoses = 3.
19. Under Fueling Point 1, select Hose 1, then Grade Association.
20. Select from the drop down menu the grade associated with Hose 1. Click OK.
21. Select
Position.