Franklin Fueling Systems T5 Series Fuel Management System Programming Guide - Manual (Page 24)

20
Programming System Parameters
Using the touch screen function of the console to program, navigate from the Home Status screen by pressing the Main
Menu button.
At the Main Menu, press the Setup button, and select System ID.
The System ID screen looks like this:
To make a modification, select the parameter that you want to change.
Type the new setting in using the characters available. When finished,
press the check-mark. When Confirmation is displayed, press Yes to
save and apply, or No to exit without saving — you may press cancel
to continue making changes. Changes will not be applied until you
return to the main menu.
Refer to the programming tables on the following pages for a more
descriptive representation of each option including the submenus of
each menu item. The console will update the menus as additional
data or information is required during programming.
Please note, features appearing in this guide may not be available,
unless the option is purchased with your console. Default parameters
are noted by the use of parentheses ().
You should have the following items ready before beginning console programming:
• Site location information to setup Site ID
• Communications parameters for external equipment to match console settings
• Wiring diagrams of site if necessary; to identify sensor and/or probe location
• Manufacturers Tank Charts for “special” tank correction tables
• Probe stickers with gradient and RTD location for “special” probes
System ID
Group Name
Parameter
Name
Parameter
Value
Description
Max
Characters
System ID Site Name (Site Name) Physical name of site. 40
Web UI URL (http://localhost/tsa) URL address of site. 40
ID Line 1 (blank) These lines should contain the physical address of the site. This
information will be used in the header of reports and to identify
site properties when using web UI.
40
ID Line 2 (blank) 40
ID Line 3 (blank) 40
ID Line 4 (blank) 40
ID Line 5 (blank) 40
System Configuration
Group Name Parameter Name
Parameter
Default
Description
Parameter
Input
System Configuration Technical Support Key (0) Enter the appropriate key number. 0-1
Enable Log Files (No) Enables the logging option. Yes/No
Modules Expected IO (0) These settings are preset by ordered options. This
value represents the number of each module installed.
When a module is installed, the console will open more
options base on which module will be utilized.
0-6
AC Input (0) 0-6
Relay (0) 0-6
Probe (0) 0-6
2-Wire Sensor (0) 0-6
3-Wire Sensor (0) 0-6
4-20mA Input (0) 0-6
Printer (0) 0-1
LON (0) 0-1
DIM (0) 0-2
Console DTU (0) 0-1