Franklin Fueling Systems TS-LLD Changing the TS-LLD Control Unit Faceplate - Manual

I N T E L L I G E N T C O N T R O L S I N C h t t p : / / w w w . i n t e l c o n . c o m
7 4 I N D U S T R I A L P A R K R D S A C O M E 0 4 0 7 2 U S A
Replacement Parts Instructions
0000229A.DOC
E - m a i l : t e c h @ i n t e l c o n . c o m F A X 1 - 2 0 7 - 2 8 2 - 9 0 0 2 T E L 1 - 8 0 0 - 9 8 4 - 6 2 6 6 P A G E 1 o f 1
s a l e s @ i n t e l c o n . c o m F A X 1 - 2 0 7 - 2 8 3 - 0 1 5 8 T E L 1 - 8 0 0 - 8 7 2 - 3 4 5 5
Line #
Control Unit cover
Product
Changing the TS-LLD Control Unit Faceplate
Parts Required:
1. TS-LLD Installation Manual (INCON P/N 000-1359)
2. New LSSP-FPU Faceplate replacement part for the TS-LLD Control Unit (CU)
Tools Required:
1. Flat-bladed screwdrivers (assorted sizes)
2. Wire Strippers, cutters, and crimp splice tool
3. Indelible ink pen or black ball point pen
Old TS-LLD Control Unit Faceplate – Removal Steps:
1. DANGER disconnect electrical power as described in the CU Installation &
Wiring and in the Safety section of the TS-LLD Installation Manual.
2. Remove the 4 hold-down screws and remove the old faceplate.
3. Record the configuration jumper link positions of J2.
New Control Unit – Installation:
1. Follow the Safety Instructions , the steps 1 through 3 for the Control Unit
Faceplate Installation , and the After Installation Steps / Testing (as detailed
in the TS-LLD Installation Manual).
2. Install the 4 faceplate hold-down screws, and
3. Write the Line # and Product on the new faceplate label.
Return the old Control Unit Faceplate:
Bag / box the old faceplate and contact INCON Technical Service Department for an
RMA number, the exact Return Shipping Address and other instructions that may be
required. Call toll free at 1-800-984-6266.
— ❖ —