Franklin Fueling Systems TS-LLD Changing the TS-LLD Control Unit - Manual

I N T E L L I G E N T C O N T R O L S I N C h t t p : / / w w w . i n t e l c o n . c o m
7 4 I N D U S T R I A L P A R K R D S A C O M E 0 4 0 7 2 U S A
Replacement Parts Instructions
0000227A.DOC
E - m a i l : t e c h @ i n t e l c o n . c o m F A X 1 - 2 0 7 - 2 8 2 - 9 0 0 2 T E L 1 - 8 0 0 - 9 8 4 - 6 2 6 6 P A G E 1 o f 1
s a l e s @ i n t e l c o n . c o m F A X 1 - 2 0 7 - 2 8 3 - 0 1 5 8 T E L 1 - 8 0 0 - 8 7 2 - 3 4 5 5
Changing the TS-LLD Control Unit
Parts Required:
1. TS-LLD Installation Manual (INCON P/N 000-1359)
2. Control Unit ( CU ) replacement part (LSSP-CU)
Tools Required:
1. Adjustable Wrench
2. Flat-bladed screwdrivers (assorted sizes)
3. Wire Strippers, cutters, and crimp splice tool
4. Indelible ink pen or black ball point pen
Old TS-LLD Control Unit – Removal Steps:
1. DANGER disconnect electrical power as described in the TS-LLD CU
Installation & Wiring and in the Safety section of that manual.
2. Remove the 4 hold-down screws and remove the old faceplate and record the
jumper link positions of J2.
3. Remove the 7 wire connections at the pump relay box from the Control Unit.
4. If present, Label and remove any wiring at TB2 and the top conduit fitting.
5. Unscrew the conduit fitting inside of the Control Unit to remove it.
New Control Unit – Installation:
Follow the Safety Instructions , and the installation steps for the new CU
enclosure, install the CU faceplate , install the fitting and any wiring that was
terminated at TB2, and follow the After Installation Steps / Testing (as detailed
in the Installation Manual).
Return the old Control Unit:
Bag / box the old Control Unit and old faceplate. Contact INCON Technical Service
Department for an RMA number, for the exact Return Shipping Address, and for any
other instructions that may be needed. Call toll free at 1-800-984-6266.
— ❖ —