Franklin Fueling Systems Colibri: Connecting a T5 Series Fuel Management System or Colibri Tank Monitor to an ALVIC SCS3 Point of Sale System User Manual
Technical bulletin, Overview, Requirements
7.55"
RADIUS
11.70"
5.80"
3.00"
RISER/COLUMN PIPE
DISCHARGE/LEAK DETEC TO R
CENTERLINE
CENTERLINE
LINE TEST PO RT
10.45"
8.12"
RADIUS
UP FOR SE
R VICE
DOWN FOR TEST
LINE
PRESSURE
TEST
R
E
C
E
L
E
T
R E
MO
VIN
G
CO
VE
R
TIG
HT
R
D
I
R
E
'
V
E
L
N
V
U
O
C
R
N
C
A V
L E
A
V
U
O
T
I
I
U
K E
E P
CO
VE
R
B E
FO
R E
OP
E N
CI
R C
UI
T
E
L
C
R
OP
E N
CIR
CU
IT
R E
MO
VIN
G
CO
VE
R
B E
FO
R E
E
CO
VE
R
TIG
HT
K E
E P
V
R
E
U
O
C
U
I
LC
T
E N
'D
C
L
N
V A
A
E
E V
E
L
R
R
I
E
L
T
C
RI
V R
OU
8.00"
5.75"
6.75"
6.31"
3.31"
4.94"
11.00"
6.31"
3.13"
3" PIPE PLUG IF ONL
Y ON
E
SIDE OF MANIFOLD USED
(FURNISHED BY CUST
OMER)
CA
L MAKEUP
POINT (1" NPT
)
TANK PO
RT
TECHNICAL
BULLETIN
June 19, 2014 • TB0614-01
Connecting a T5 Series Fuel Management System or Colibri Tank Monitor to
an ALVIC SCS3 Point of Sale System
Overview
This document explains how to connect a T5 Series Fuel Management System or Colibri Tank Monitor to an ALVIC
SCS3 System and allow the ALVIC system to receive inventory information from the T5 Series or Colibri tank monitor.
In applications where dispenser reconciliation is desired, it will also allow the ALVIC system to send sales information
to the T5 Series or Colibri Tank Monitor, without the need for a TS-DIMIB (Dispenser Interface Module).
Requirements
• T5 Series Controller Module software version 1.8.0.6620 or greater. Colibri version 1.8.3.7080.
Communications
On the ALVIC System, Configuring SCS3 for a Franklin ATG
For the SCS3 to work with Franklin Fueling Systems T5 series and Colibri tank monitors, you need to configure the
SCS3.XML file with the following parameters.
Add the following nodes after the
Replace the IP: 192.168.168.168 with the correct one that corresponds to the console.
The parameter admin should only be changed if the administrator password at the tank gauge monitor had been
changed from factory defaults, and should be replaced by the new administrator password.
Example: