Franklin Fueling Systems T5 Series Fuel Management System Programming Guide - Manual (Page 6)

2
Certified Programmer/Service Person: Only an FFS certified programmer or service person is allowed to access both
the user interface keypad and areas internal to the Fuel Management System console.
Station Owner/Operator: The station owner or operator of the Fuel Management System console is only allowed to
access the user interface keypad. Access to areas internal to the console is strictly prohibited.
Approvals
All Fuel Management System models are UL and cUL listed 6L79 as Liquid Level Gauge / Leak Detection
Systems. Third party approved leak detection — Pd (probability of detection) = 99.2 % for 0.1 or 0.2 gph leak tests
(0.1 = annual precision test, 0.2 is the monthly regulatory compliance test).
*The static tank test does not support Manifolded tanks.
**SCALD is 3rd party approved for ONLY two Manifolded tanks.
Substituting components could impair intrinsic safety. T5XXXs are intrinsically safe for sensors
installed in – Class I, Division 1, Group D – hazardous locations. Substitution of components could
make the energy limiting circuitry in the system ineffective and could cause an explosion hazard.
Repairs to a T5XXX console or attached components should only be performed by a qualified,
factory-trained technician.
Warning