Franklin Fueling Systems Tank Sentinel, AutoStik, BulkStik Printer Assembly (P/N 020-3050) - Manual

www.franklinfueling.com
PN & Rev: 0000202B
E - m a i l : t e c h @ f r a n k l i n f u e l i n g . c o m F A X 1 - 2 0 7 - 2 8 2 - 9 0 0 2 T E L 1 - 8 0 0 - 9 8 4 - 6 2 6 6 P AG E 1 o f 1
s a l e s @ f r a n k l i n f u e l i n g . c o m F A X 1 - 2 0 7 - 2 8 3 - 0 1 5 8 T E L 1 - 8 0 0 - 8 7 2 - 3 4 5 5
REPLACEMENT
PART
INSTRUCTIONS
Tank Sentinel, AutoStik, BulkStik Printer Assembly (P/N 020-3050):
Diagram: 1
Removal Steps (with all Tank Gauge power OFF ):
1.) Remove the Printer’s hinged cover / door (see P/N 000-0201_.doc).
2.) Remove the two 11/32 inch hex fasteners as shown above
3.) Remove the 26 conductor Cable by pulling it straight out from the printer
connector
4.) Raise the printer assembly slightly and twist about 45 degrees to clear the printer
door hinge posts and finally pull the assembly out of the door
Installation Steps (with all Tank Gauge power OFF ):
1.) Twist the printer assembly about 45 degrees to clear the printer door hinge posts
insert the printer and rotate it back again in a vertical position
2.) Use both hands and plug-in the 26 conductor cable back into the mating connector
under the PRINTER PC B d (gloss side up silver conductor side down)
3.) Reinstall the two 11/32 inch hex fasteners, as shown above, and install the printer
cover (see instructions P/N 000-0201.doc).
— ❖ —
Printer's
hinged
cover
(door)
Printer - Side View
11/32 inch hex
Printer - Back View (Behind Door)
Push
cable in -
glossy
side up,
silver
conductor
side down
Cable