Extron Electronics MLC 226 IP Series Installation - Manual (Page 130)

Special Applications, cont’d
MLC 226 IP Series • Special Applications 6-12
PRELIMINAR
Y
To confi gure the MLC to control two projectors using the MLC’s Display power
buttons, perform these steps:
1. Open or create a new Global Confi gurator project that includes an MLC.
2. In the IP Link tree view window, click on the MLC to be confi gured.
3. Click on MLS Port. The MLS Port tab displays in the right side of the window.
N If you create a new project, this port is labeled as “MLS Port” in the IP Link tree
view. If you open an existing project that was created with an earlier version of
software, the port is labeled “Slave Switcher” instead.
4. Select the Disable MLS support (Enable serial driver support) radio button.
5. On the “Confi rm auxiliary switcher port change” prompt that appears, click
OK.
6. Under Control Ports in the IP Link tree window on the left, select MLS Port.
7. Select the Driver Configuration tab.
8. In the Serial Driver Selection area, select the device type and model of the
projector that will be connected to the MLS port.
9. Click the Add Driver ( ) button.
10. Click the Front Panel tab.
11. Click the Display On button.