Xylem CHATTER RTU and E-mail - Manual (Page 94)

USERS MANUAL
CHATTER™ DATA LOGGER
94
Call on alarm OFF
Select between No and Yes.
If you select Yes, the Chatter™ Data Logger will make
an alarm call using the Alarm call list when an alarm
condition no longer exists
Additional information:
Setting the alarm call list
Use alarm retention interval
Select between No and Yes.
If you select Yes, the Chatter™ Data Logger will make
an alarm call using the Alarm call list when an alarm
condition exists. It will not react to new alarms from
this Instrument Net input before the Alarm retention
interval runs out.
If you select N o , the Chatter™ Data Logger will make
an alarm call for every new alarm on this Instrument
Net input.
You will get repeated alarms from this
input if an alarm is started on another input
before the alarm retention time runs out..
Any new alarm on an input calls all entries
in the Alarm call list and delivers alarm
status for all inputs to the recipients.
Additional information:
Setting the alarm retention interval
Setting the alarm call list
Scale 0%
The default value is 0, please read about Scaling and Calibration before you change this value.
A dditional inform ation:
Scaling and calibration
Changing output values
Scale 100%
The default value is 1, please read about Scaling and Calibration before you change this value.
A dditional inform ation:
Scaling and calibration
Changing output values
Calibration 0%
The default value is 0, please read about Scaling and Calibration before you change this value.
A dditional inform ation:
Scaling and calibration
Changing output values
Calibration 100%
111
112
111
172
175
172
175
172
175