Xylem CHATTER RTU and E-mail User Manual
Page 42
USERS MANUAL
CHATTER™ DATA LOGGER
42
Select how often you want to measure the level using the
InstrumentNet sensor and how often you want the Chatter™
Data Logger to send an e-mail to deliver the measured data.
Click the button with the arrow to continue.
A dditional inform ation:
Data log schedule
Data call schedules
You must provide a valid e-mail addresses for:
The mailbox which will receive e-mails from this Chatter™
Data Logger
This Chatter™ Data Logger. This e-mail address is used as
the sender address.
Ask your mobile telephone supplier which
sender address you may use.
The text box turns red if an invalid the e-mail
address is entered
A dditional inform ation:
Enter the Access Point Name needed for GPRS
communication. The APN depends on which GPRS network
you will use. In general, there are two possibilities:
If you are using a private network like MPLS, your network
supplier will tell you which APN to use.
If you are using a public network, your telecom supplier
will tell you what their APN is.
Enter the pin-code for the SIM-card is a pin-code is used.
Leave the field empty if you don't use a pin-code
Enter the server address for outgoing e-mail. This address
will normally be provided by your mobile telecom provider.
The default port for e-mail traffic is 25, do not
change this unless you are specifically instructed
to do so
The modem built into the Chatter™ Data
Logger does NOT support mail servers which
requires a secure logon.
The text box turns red if an invalid the mail
server address is used
A dditional inform ation:
Internet settings
GSM/GPRS setup
e-mail setup
103
105
124
119
118
124