Xylem CHATTER RTU and E-mail - Manual (Page 71)

USERS MANUAL
CHATTER™ DATA LOGGER
71
Rising rate limit
In use?
Select between No and Yes.
Select if the rising rate limit is in use or not in use.
Signal name
Select an existing signal name or enter a new signal name.
The signal name will act as an identifier for rising rate limit, inserted into any SMS messages and e-mails
sent from this Chatter™ Data Logger
Additional information:
Signal names explained
Set point
Enter the value you want to use as the rising rate limit
Passing this limit will either put the Chatter™ Data Logger
into event mode if
Event m ode is enabled or start an
alarm if C all on alarm O N is enabled.
Additional information:
Working in event mode
Delay [Samples]
Enter the number of samples, you want the signal on the
rising rate limit to be above the limit before the
measurement is considered valid.
The delay can be between 0 and 250 samples.
Additional information:
Setting the data log interval
The actual delay time varies, it depends on the
what the Chatter™ Data Logger is doing right
now:
If the Chatter™ Data Logger is in working in
Event mode, the sample time is the Event log
interval
A dditional inform ation:
Working in event mode
If the Chatter™ Data Logger is working in
normal mode, the sample time is the Data
160
171
171