Xylem CHATTER RTU and E-mail - Manual (Page 33)

USERS MANUAL
CHATTER™ DATA LOGGER
33
RTU wizard
The first step is to connect with a Chatter™ Data Logger
Click the button Start
You may change the built-in firmware to:
e-mail version
Database version
Select the firmware version you will change to.
You may change the built-in firmware to a
database version.
The Chatter™ Link PC program does not
support the setup of a Chatter™ Data Logger
connected to a database.
This warning is shown if you are using the RTU wizard for a
Chatter™ Data Logger with a non-RTU firmware.
There is a delay before the Yes-button will be
active
The Chatter™ Data Logger must be connected to an
InstrumentNet sensor and a valid SIM-card inserted.
If the InstrumentNet sensor and the SIM-card are missing, exit
the wizard.
Connect the GE Proficy iFix version 5 Historian sensor and
the SIM-card and start the wizard again.
Click the button with the arrow to continue.
Select how often you want to measure the level using the
InstrumentNet sensor and how often you want the Chatter™
Data Logger to make a call to deliver the measured data.
Click the button with the arrow to continue.
A dditional inform ation:
Data log schedule
Data call schedules
136
103
105