Xylem CHATTER RTU and E-mail - Manual (Page 41)

USERS MANUAL
CHATTER™ DATA LOGGER
41
e-mail wizard
The first step is to connect with a Chatter™ Data Logger
Click the button Start
You may change the built-in firmware to:
RTU version
Database version
Select the firmware version you will change to.
You may change the built-in firmware to a
database version.
The Chatter™ Link PC program does not
support the setup of a Chatter™ Data Logger
connected to a database.
This warning is shown if you are using the e-mail wizard for a
Chatter™ Data Logger with a non-e-mail firmware.
There is a delay before the Yes-button will be
active
The Chatter™ Data Logger must be connected to an
InstrumentNet sensor and a valid SIM-card inserted.
If the InstrumentNet sensor and the SIM-card are missing, exit
the wizard.
Connect the GE Proficy iFix version 5 Historian sensor and
the SIM-card and start the wizard again.
Click the button with the arrow to continue.
Enter a name for this low limit
The name is used to identify e-mails sent from this Chatter™
Data Logger
Click the button with the arrow to continue.
A dditional inform ation:
Chatter name
136
114