Setup, Setup pane – Xylem CHATTER RTU and E-mail User Manual

Page 84

USERS MANUAL

CHATTER™ DATA LOGGER

Setup

Use this pane to set the way each of the four
analog input will operate. See below for a
detailed description of each part in this pane.

Signal name

Select an existing signal name or enter a new signal name.

The signal name will act as an identifier for this input. It is inserted into any SMS messages and e-mails sent
from this analog input.

Additional information:

Unit type

Select an existing unit type or select an empty position in the list and enter a new unit type.

The unit type will act as an identifier for the measured value. It is inserted into any SMS messages and e-
mails sent from this analog input.

Additional information:

Measuring units

Number of decimals

This setting determines how many decimals you will see in an SMS message or e-mail sent from this
analog input.

Select the number of decimals you need, you can select from zero to eight digits after the decimal point.

The Chatter™ Data Logger stores the measured value internally with the maximum precision
regardless of this setting.

Call on alarm ON

Select between No and Yes.

If you select

Ye s

, the Chatter™ Data Logger will make an

alarm call when the high limit is passed on a rising slope
and the

D elay [Sam ples]

is over

It will call all entries in the Alarm call list, starting with the
first entry.

A dditional inform ation:

Call on alarm OFF

160

167

111