Xylem CHATTER RTU and E-mail - Manual (Page 81)

USERS MANUAL
CHATTER™ DATA LOGGER
81
Advanced
Use this window to set the way each of the four digital
input will operate.
The data shown are only accurate when
your PC is connected to the Chatter™
Data Logger with a USB-cable, otherwise it
will show the data from the last time, you
were connected to the Chatter™ Data
Logger
A dditional inform ation:
Setup pane
Alarm pane
Scan AI/INET with event interval (if active)
Select between No and Yes.
If you select Yes,
Do not log this on Log all
Select between No and Yes.
If you select Yes,
Always log with log interval
Select between No and Yes.
If you select Yes,
Always log with event interval
Select between No and Yes.
If you select Yes, this input will set the Chatter™ Data Logger to event mode when it is activated..
Additional information:
Working in event mode
Log schedule
Log on Status/Limit change
Select between No and Yes.
If you select Yes, the
Log all once on Status/Limit change
Select between No and Yes.
If you select Yes,
Log all with event int. if Status/Limit active
Select between No and Yes.
If you select Yes,
Log this with event int. if Status/Limit active
Select between No and Yes.
If you select Yes,
77
79
171
103