ZyXEL Communications Centralized Network Management Vantage CNM - Manual (Page 69)

Chapter 5 Device Network Settings
Vantage CNM User’s Guide
69
5.3.1 WAN1 (ZyNOS ZyWALL with one WAN port)
The screen differs by the encapsulation type chosen.
Figure 32 Device Operation > Device Configuration > Network > WAN > WAN1 (ZyNOS
ZyWALL with one WAN port)
Allow between
WAN2 and
DMZ Select this check box to forward NetBIOS packets from the WAN2 port to the DMZ
port and from the DMZ port to WAN2.
Clear this check box to block all NetBIOS packets going from the WAN2 port to the
DMZ port and from DMZ port to WAN2.
Allow between
WAN2 and
WLAN Select this check box to forward NetBIOS packets from the WAN2 port to the WLAN
port and from the WLAN port to WAN2.
Clear this check box to block all NetBIOS packets going from the WAN2 port to the
WLAN port and from WLAN port to WAN2.
Allow Trigger
Dial Select this option to allow NetBIOS packets to initiate calls.
Apply Click Apply to save your changes back to the device.
Reset Click Reset to begin configuring this screen afresh.
Table 17 Device Operation > Device Configuration > Network > WAN > General (ZyNOS
ZyWALL) (continued)
LABEL DESCRIPTION