ZyXEL Communications Centralized Network Management Vantage CNM - Manual (Page 193)

Chapter 7 Device Advanced Settings
Vantage CNM User’s Guide
193
7.5 Static Route
This section shows you how to configure the Static Route screens. These screens may vary
depending on which model you’re configuring. Please see the device’s User’s Guide for more
information about any of these screens or fields.
7.6 Static Route
Use this screen to tell the device about networks that are not directly connected to the device.
To open this screen, click a device, click Device Operation in the menu bar and then click
Device Configuration > Advanced > Static Route in the navigation panel.
Figure 92 Device Operation > Device Configuration > Advanced > Static Route
Incoming Start
Port Type a port number or the starting port number in a range of port numbers.
Incoming End
Port Type a port number or the ending port number in a range of port numbers.
The trigger port is a port (or a range of ports) that causes (or triggers) the device to
record the IP address of the LAN computer that sent the traffic to a server on the
WAN.
Trigger Start
Port Type a port number or the starting port number in a range of port numbers.
Trigger End
Port Type a port number or the ending port number in a range of port numbers.
Apply Click Apply to save your changes back to the device.
Cancel Click Cancel to return to the previous screen.
Table 81 Device Operation > Device Configuration > Advanced > NAT > Trigger Port > Edit
LABEL DESCRIPTION