ZyXEL Communications Centralized Network Management Vantage CNM - Manual (Page 65)

Chapter 5 Device Network Settings
Vantage CNM User’s Guide
65
Use this screen to assign IP addresses to specific individual computers on the LAN based on
their MAC addresses. To open this screen, click Device Operation in the menu bar, and click
Device Configuration > Network > LAN > Static DHCP in the navigation panel.
Figure 29 Device Operation > Device Configuration > Network > LAN > Static DHCP
The following table describes the fields in this screen.
5.2.2 IP Alias
"
This section refers only to the LAN screen, but the information is applicable for
the LAN, WLAN, and DMZ screens.
Use this screen to configure logical interfaces (subnets) via its single physical Ethernet
interface with the device itself being the gateway for each network. You can also configure
firewall rules to control access between the logical networks. To open this screen, click Device
Operation > Device Configuration > Network > LAN > IP Alias.
Table 15 Device Operation > Device Configuration > Network > LAN > Static DHCP
LABEL DESCRIPTION
Index This is the index number of the Static IP table entry (row).
MAC Address This is the MAC address of a computer on the device’s LAN.
IP Address This is the IP address to be assigned to the device with the MAC address above.
Apply Click Apply to save your changes back to the device.
Reset Click Reset to begin configuring this screen afresh.