ZyXEL Communications Centralized Network Management Vantage CNM - Manual (Page 301)

Chapter 21 CNM System Setting
Vantage CNM User’s Guide
301
21.1.1 Vantage CNM Server Public IP Address
If you change the Vantage CNM server public IP address, then each (Vantage CNM-
registered) device’s Manager IP address must change too.
1 Go to the CNM System Settings > Configuration > Servers > Configuration screen.
2 Enter the new IP address in the Public IP Address field and Apply.
3 Change all registered devices’ manager IP address to the new IP address, you must
access each device’s web interface or command line.
• For ZyNOS ZyWALL, go to ADVANCED > REMOTE MGMT > CNM tab in the
web interface. Enter the new Vantage CNM public IP address and then click Apply.
• For ZLD ZyWALL, go to System > Vantage CNM in the web interface. Enter the
new Vantage CNM public IP address and then click Apply.
• For Prestige, go to command line and enter cnm managerIp x.x.x.x on the ZyXEL
device where x.x.x.x is the public IP address of the Vantage CNM server.
4 Restart managed devices or restart Vantage CNM (see 4a and 4b ) to reset the
communication between Vantage CNM and devices. Wait about 5 minutes until the
device is ready and registers with Vantage CNM. You don’t have to restart the computer
on which Vantage CNM is installed. See how to restart Vantage CNM as following.
4a Right-click the Vantage CNM icon in the system tray and select
STOP.
4b Right-click the icon again and select START.
When you register new devices with Vantage CNM, make sure the new device can ping the
Vantage CNM server (the new Vantage CNM Public IP address) and then set the device’s
Manager IP address correspondingly.
21.2 Servers Status
Use this screen to view the current Vantage CNM system status. This is a read-only screen. To
open this screen, click CNM System Setting in the menu bar and then click Configuration >
Servers > Status in the navigation panel.
Password Type the mail server password associated with the login name.
Apply Click Apply to save your settings in Vantage CNM.
Reset Click Reset to begin configuring the screen afresh.
Table 146 CNM System Setting > Configuration > Servers > Configuration
LABEL DESCRIPTION