Toshiba STRATA CIX - Manual (Page 10)

Telephone Button Programming
Button Programming Examples
1-6
Strata CIX/CTX Telephone Button Programming 11/04
Program 204
Reference ìProgram 204î on page 34 and review Summary column field descriptions. This program
enables you to setup the DKT parameters.
1. Enter programming mode. See ì Step 1: Enter Program Mode on page 1-7 ."
2. At the PROG= prompt enter
204
and press
Hold
.
3. At the DN= prompt enter
1000
(n) and press
Hold
.
4. Press
FB01
. Press
1
to select a Extension and press
Hold
.
5. Press
FB02
. Press
3
to select Pattern 3 for this DKT and press
Hold
.
For this example, we are using a 20-button DKT. There are three button patterns to choose from for
each type of digital telephone.
Only the above FB s need to be assigned. Press Hold again before proceeding to the next step.
6. Press
##Hold
to return to the PROG= prompt.
Note Additional assignments can be made to fine tune DKT parameters. See Summary column for field
descriptions and default values. If specific assignments are not made, the system automatically
assigns the default value.
Program 205
Reference ìProgram 205î on page 39 and ìFeature/Button Code Parameter Assignmentsî on page 1-41 .
This program assigns features and parameters to the FB buttons on your DKT telephone. In this example,
the
FB10 button on your DKT will be programmed to act as a GCO button.
1. Enter programming mode. See ì Step 1: Enter Program Mode on page 1-7 ."
2. At the PROG= prompt enter
205
and press
Hold
.
3. At the DN= prompt enter
1000
(n) and press
Hold
.
4. Press FB10 . Enter 130 to assign a GCO and press Spkr .
To select the n1, n2, n3, n4 and n5 values required in “Program 205” on page 39 , see “GCO” in the
table titled “Feature/Button Code Parameter Assignments” on page 1-41 .
5. Enter 1 to assign a GCO number and press Spkr .
6. Enter 1 to assign a GCO index and press Spkr .
7. Enter
2
to enable immediate ringing for this GCO and press
Spkr
.
8. Enter
1
to assign a soft ring tone to this GCO and press
Spkr
.
9. Enter
900
to assign an Owner DN to this GCO number and press
Hold
twice.
10.Press
##Hold
to return to the PROG= prompt.
Note Press ##Hold again to exit Button Programming Mode.
Program 208
Reference ìProgram 208î on page 46 . This program assigns timing parameters to Primary DNs.
1. Enter programming mode. See ì Step 1: Enter Program Mode on page 1-7 ."
2. At the PROG= prompt enter 208 and press Hold .
3. At the DN= prompt enter 1000 (n) and press Hold .
4. Press FB01 . Press 10 to set the number of ABR attempts and press Hold .
5. Press FB02 . Press 60 to set ABR to attempt redials in 60 second increments and press Hold .
6. Press FB03 . Press 20 to set the ABR Recall Timer and press Hold .