Omron Programmable Terminals NT31 NT31C - Manual (Page 180)

6-9 Section System Settings
170
Set the system start-up wait time by following the menu operation from the Sys-
tem Menu shown below.
Select Maintenance Mode.
Select Memory Switch.
Press Start-up Wait Time to display the re-
quired time lapse.
The setting option changes each time the
touch switch is pressed, according to the fol-
lowing sequence.
01 02 03 .... 09 10 00 01 ....
Ver 3.10
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press the
Quit touch switch. The settings made last will be set and the NT31/NT31C will
return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings, press
the Abort touch switch. The NT31/NT31C will return to the MAINTENANCE
MODE MENU screen with the previous settings still in effect.
6-9-3 Setting the Key Press Sound
It is possible to set whether or not the key sound is sounded when a touch switch
on the NT31/NT31C screen is pressed.
• ON: When a touch switch is pressed, the key sound sounds for 0.2 seconds.
• OFF: The key sound does not sound when touch switches are pressed.
The default (factory) setting is ON.