7-2 setting the host link method – Omron Programmable Terminals NT31 NT31C User Manual
Page 170
6-7
Section
Setting Conditions for Communications with Host by Using Memory Switches
160
6-7-2 Setting the Host Link Method
Set the communication conditions for the host link method at serial port A or seri-
al port B by following the operation from the System Menu shown below.
Select Maintenance Mode.
Select Memory Switch.
Display the fourth memory switch screen by
pressing the [
↓] (next screen) or [↑] (pre-
vious screen) touch switch.
Press the touch switch corresponding to the
port at which the host link method is to be set
(Comm. A Method or Comm. B Method) to
display the setting option Host Link.
The setting option changes each time the
touch switch is pressed.
Ver 3.10