Omron Programmable Terminals NT31 NT31C - Manual (Page 109)

5-1 Section Connecting to the Host’s RS-232C Port
98
Name Delivered with Remarks Model
XM2S-0911
9-pin type
Made by OMRON
C-series CQM1, C200HS,
C200HX/HG/HE(-Z)E
CVM1/CV-series CPUs
CV500-LK201
XM2S-0913 Made by OMRON 9-pin ---
Connector
hood
XM2S-0911-E Made by OMRON 9-pin CS1 series CS1G/CS1H
hood
XM2S-2511
25-pin type
Made by OMRON
C500-LK203
3G2A5-LK201-EV1
C200H-LK201-V1
DB-C2-J9
25-pin type
Made by JAE
3G2A5-LK201-EV1
3G2A6-LK201-EV1
Cable
AWG28
5P
IFVV-SB
Multi-core shielded cable
Made by Fujikura, Ltd.
---
Cable
CO-MA-VV-SB
5P
28AWG
Multi-core shielded cable
Made by Hitachi, Ltd.
---
Cables with Connectors Made by OMRON
When connecting an NT-AL001 and a PC, use the OMRON cables with connec-
tors indicated in the table below.
Model Cable Length Connector Specification
XW2Z-200S 2 m 9-pin ⇔ 25-pin
XW2Z-500S 5 m
9 pin ⇔ 25 pin
Host link, NT link (1:1)
XW2Z-200T 2 m 9-pin ⇔ 9-pin
XW2Z-500T 5 m
9 pin ⇔ 9 pin
Host link, NT link (1:1)
SJ45007-102
1 m 9-pin
⇔ 9-pin
Host link, NT link (1:1)
SJ45007-202
2 m
Host link, NT link (1:1)
+5 V power supply wire attached
(Use when the PC does not have a +5 V output.)
XW2Z-070T-1
0.7 m 9-pin
⇔ 9-pin
Host link, NT link (1:1), NT link (1:N)
XW2Z-200T-1
2 m
Host link, NT link (1:1), NT link (1:N)
+5 V power supplied from PC
(Use when the PC has a +5 V output.)
SJ46006-102
1 m 9-pin
⇔ 9-pin
Host link, NT link (1:1), NT link (1:N)
SJ46006-202
2 m
Host link, NT link (1:1), NT link (1:N)
+5 V power supplied from PC
(Use when the PC has a +5 V output.)
Note The maximum tensile load of the recommended cable is 30 N. Do not exceed
this load.
• After connecting a connecting cable, always tighten the connector screws.
• Recommended connectors, cables and crimp terminals for RS-422A/485
When making an RS-422A/485 connecting cable, as far as possible use the
recommended parts indicated in the table below. Some units come supplied
with one connector and connector hood.
Check the required parts and prepare them in advance.