Omron Programmable Terminals NT31 NT31C - Manual (Page 179)

6-9 Section System Settings
169
The four memory switch setting screens are shown below.
[ ] (next screen)
[ ] (next screen) [ ] (previous screen)
[ ] (previous screen)
[ ] (next screen) [ ] (previous screen)
[ ] (next screen)
[ ] (previous screen)
Memory Switch Settings
A list of the memory switch settings is presented below.
• Start-up Wait Time
page 169
• Key Press Sound
page 170
• Buzzer Sound
page 171
• Printer Controller
page 172
• Print Method page 174
• Screen Saver Movement
page 175
• Screen Saver Start up Time
page 177
• Hist. Disp. Method page 179
• Resume Function
page 181
• Comm. Auto-return
page 183
• Time-out Interval
page 185
• Retry Counts
page 186
• Comm. A Method page 157
(For the bar code reader, refer to page 188.)
• Comm. B Select
page 167
• Comm. B Method page 157
For details on each setting, refer to the pages indicated.
6-9-2 Setting the Start-up Wait Time
The Start-up Wait Time is the time lapse until the NT31/NT31C switches to the
RUN mode after its power has been switched ON or after it has been reset. Set
this item if it takes some time for the host to start operation. Nothing is displayed
during the Start-up Wait Time.
The setting range is 0 to 10 seconds. The default (factory) setting is 00sec.