Omron Programmable Terminals NT31 NT31C - Manual (Page 172)

6-7 Section Setting Conditions for Communications with Host by Using Memory Switches
162
6-7-3 Setting the NT Link (1:1) Method
Set the communication conditions for the NT link (1:1) method at serial port A or
serial port B by following the operation from the System Menu shown below.
Select Maintenance Mode.
Select Memory Switch.
Display the fourth memory switch screen by
pressing the [
↓] (next screen) or [↑] (previous
screen) touch switch.
Press the touch switch corresponding to the
port at which the NT link (1:1) method is to be
set (Comm. A Method or Comm. B Method) to
display the setting option NT Link (1:1).
Ver 3.10
The setting option changes each time the touch switch is pressed.
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press the
Quit touch switch. The settings made last will be set and the NT31/NT31C will
return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings, press
the Abort touch switch. The NT31/NT31C will return to the MAINTENANCE
MODE MENU screen with the previous settings still in effect.