Renesas 4514 - Manual (Page 205)

3-38
APPENDIX
4513/4514 Group User’s Manual
3.6 Mark specification form
42P2R-A (42-PIN SHRINK SOP) MARK SPECIFICATION FORM
Mitsubishi IC catalog name
Please choose one of the marking types below (A, B, C), and enter the Mitsubishi catalog name and the special mark (if needed).
A. Standard Mitsubishi Mark
C. Special Mark Required
B. Customer’s Parts Number + Mitsubishi catalog name
Mitsubishi IC catalog name
Mitsubishi IC catalog name
Note1 : If the Special Mark is to be Printed, indicate the desired
layout of the mark in the left figure. The layout will be
duplicated as close as possible.
Mitsubishi lot number (6-digit or 7-digit) and Mask ROM
number (3-digit) are always marked.
2 : If the customer’s trade mark logo must be used in the
Special Mark, check the box below.
Please submit a clean original of the logo.
For the new special character fonts a clean font original
(ideally logo drawing) must be submitted.
Special logo required
Customer’s Par ts Number
Note : The fonts and size of characters are standard Mitsubishi type.
Mitsubishi IC catalog name
Note1 : The mark field should be written right aligned.
2 : The fonts and size of characters are standard Mitsubishi type.
3 : Customer’s Parts Number can be up to 11 characters : Only 0 ~
9, A ~ Z, +, –, /, (, ), &,

,
.
(periods),
,
(commas) are usable.
4 : If the Mitsubishi logo is not required, check the box below.
Mitsubishi logo is not required
Mitsubishi lot number
(6-digit or 7-digit)
1 21
22 42
Mitsubishi lot number
(6-digit or 7-digit)
1 21
22 42
1 21
22 42